...
Once the process is done, click on "Finish". You can now plug the USB key to your appliance. See below for "installing OS on the appliance".
Windows BIOS settings
If your appliance gets stuck after rebooting, please check the bios setup. To do so, press F11 after starting the device and click on "Enter setup" in the screen below:
Make sure the following configuration is set:
1. Boot > Boot Option Priorities
P1: General USB Drive
P2: [UEFI] General USB Drive
P3: SSD
2. Boot > Setup Prompt Timeout = 3
3. Advanced > Restore Power AC Loss = ON
4. Advanced > USB Configuration > XHCI Mode = Enabled
5. Chipset > DVMT Total Gfx Mem = 128MB
Installation of windows 10 on the beroNet appliance
...
Once it is finished, the appliance will reboot. After rebooting, it will try to boot from the USB stick again. In order to prevent windows for installing again, unplug the USB stick and let the appliance boot on its SSD.
Problem after reboot
If your appliance gets stuck after rebooting, please check the bios setup. To do so, press F11 after starting the device and click on "Enter setup" in the screen below:
Make sure the following configuration is set:
1. Boot > Boot Option Priorities
P1: General USB Drive
P2: [UEFI] General USB Drive
P3: SSD
2. Boot > Setup Prompt Timeout = 3
3. Advanced > Restore Power AC Loss = ON
4. Advanced > USB Configuration > XHCI Mode = Enabled
5. Chipset > DVMT Total Gfx Mem = 128MB
Drivers for windows
Once windows is ready, we advise you to install a few drivers designed for beroNet hardware. You can find the list of drivers to install here: http://beronet.com/wp-content/uploads/downloads/appliance/BNTA2/MITX_6770/Driver/
...