This Howto describes how to do a factory reset on a beroNet device. This could be useful in case of a lost password or in any case where you lost the connection to the beroNet device. This feature works only with firmware version > 1.12 and FPGA image version >= 3. The Hardware Factory Reset deletes all data on the beroNet device incl. the firmware and restores the default values. There are 8 steps how to initiate the Hardware Factory Reset.
...
- 4. In case of a box power up the device or in case of a card plug the card in your computer and power up the device.
- 5. After you power up the device it should be reachable again with the default IP address 10.0.0.2. or a new IP address, which can be identified using the bfdetect tool. Open your browser with the address and wait until you get a response from the beroNet device (this could take a couple of minutes since the device is restoring factory defaults. see . If version 17.01 or higher is installed, please wait at least 5 minutes for the gateway to be accessible again. See picture below).
- 6. After accessing the device via browser it has to be turned off again. Remove the jumper.
- 7. Power up the device again. Use your browser to access the gateway. Press the Firmware-Update button (see picture above).
- 8. Install the new firmware (see picture below).
...