The web interface of 3CX 20 is a bit different than older versions, but the configuration of a beroNet gateway with the IPBX is very similar.
...
On this page, you can create the SIP connection between the 3CX and the gateway. A few important informations need to be entered:
- "Registrar/Server/Gateway Hostname or IP": You need to enter here the IP address of your beroNet Gateway
- Main Trunk Number needs to be assigned a value containing at least four digits
- "Authentification ID" is what we call "user" in the beroNet web interface
- "Authentification Password" is what we call "secret" in the beroNet web interface
Registering the beroNet gateway
On the beroNet gateway go to SIP→SIP and click the Add button. In the pop-up fill out the values 3cx 3CX provided for registering a SIP trunk, save and click activate.
Create an outbound rule for the gateway, cutting off the first four digits (the main trunk number).
On the beronet gateway configure the inbound and outbound rules in the dialplan.
Known
...
issues with 3cx v20
Now you need to configure it to not pass all the ISDN messages to the calling SIP peer. Configure the SIP response to be 180 on an incoming ISDN ALERTING message.
...
Save and activate. Note that in the 24.01 firmware there is a bugIf bug. If you open the dialplan rule again, the value is not pre-selected in the dropdown , and saving the dialplan rule without manually selecting the Call Progress Table again would reset it. This issue has been fixed with firmware 24.01.01-rc02.