Firmware BeroNet Gateway: 16.09
Firmware 3CX:
Firmware snom360: 8.7.3.25
After installing the cloud hosted 3CX PBX, you can access the management console using the credentials shown below. Make a note of your user name and password, as there is no way to read them afterwards.
Before you start configuring 3CX and the gateway, reset the gateway if possible.
...
Enter the trunk main number in the corresponding field and confirm with OK.
Enter the IP-address of the gateway and confirm with OK. Further settings are not necessary.
After pressing Device Configuration, you will be taken to the 3CX Wizard of the beroNet Gateway.
Here you can add regionally dependent data such as the area code. Further information is not necessary. Confirm your entries with the SAVE button.
You will then be prompted for a reboot. To do this, press the red button.
After the reboot you should see the following in the Status menu:
Filter by label (Content by label) | ||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...